Sanipex KOY, Installation Manual

Page: 11 / 16

ADJUSTMENT OF HANDLES
Caution:
Do not rotate the spindle during any installation
process. Re-align the original marking lines once
the spindle was moved.
1. Spindle gear
2. O-ring
3. Set screw
4. O-ring
5. Handle
6. Set screw
7. Plug
8. Stop ring
9. Handle
Diverter Handle
Align the original
marking lines.
Thermostat Handle
Adjustment of diverter handle
12 o'clock direction. OK!
If not point to 12 O'clock,
reset the handle.
Diverter handle reset steps:
1. Take off the handle.
2. Loosen the screw #3 & 0-ring #2.
3. Take off the gear #1, and slightly rotate the
gear (in a small angle).
4. Fix on the gear then test to fix on the
handle.
5. If the handle still couldn't fixed on correct
position, repeat above Step-3.
6. Until the handle could be fixed on correctly.
Adjustment of diverter handle
Thermostat handle commissioning steps:
1. Take off the handle.
2. Take off stop ring part# 8 and rotate ii till
cutting line points to 12 o'clock, then fix it
onto the cartridge.
3. Fix on the handle.
12 o'clock direction. OK!
If not point to 12 O'clock,
reset the handle.
Rotate the stop ring till
cutting line points to 12
o'clock.