9
How To Drain
PROCEDURE TO DRAIN THE FOOT BATH
1. Turn off the foot bath by pushing the OFF button on the control module.
2. Unplug the foot bath from the electrical outlet and store the cord.
3. Put both removable lids on the tank before moving the foot bath to the area where the tank will be drained and then
remove the lids .
4. Place the Discharge Pump on the flat round surface in the bottom of the foot bath. (See Image # 1)
5. Extend the hose connected to the Discharge Pump to the area where the water is to be drained (sink). Use the
suction cup provided to secure the hose to the side of the sink and turn on the discharge pump by plugging the
pump’s power cord into a grounded circuit. (See Image # 2)
6. When the foot bath appears to be empty, continue running the pump while removing it from the interior of the foot
bath and place it in the sink or chosen draining area. As soon as the pump and hose are both fully in the sink unplug
the power cord to turn off the discharge pump. Fresh water can be used to rinse out the tank during the draining
procedure. (See Image # 2)
WARNING: Do not leave the pump running in the draining area or in a dry foot bath for more than a few seconds
because it may result in damage to the discharge pump.
WARNING: The power cord cannot be replaced; in case of any damage to the power cord the entire discharge pump
must be replaced.
To maintain your SANIJET® Pipeless™ Portable Foot Bath at a maximum level of hygiene, thoroughly clean the tub shell
and jets after each use with a nonabrasive antibacterial cleaner, rinse thoroughly, and dry completely. See Page 10 for
complete cleaning procedure. NEVER use abrasive cleaners on the foot bath.
Image #1
Image #2
