KBox B-201 - User Guide, Rev. 1.3
// 30
5.
Secure the mSATA card by pressing down on the free end and carefully fasten the mSATA card to the
mainboard with a mounting screw and spacer (if required) between the mSATA card and the mainboard.
Do not use too much force when fastening the mSATA expansion card’s mounting screw. Too
much force may damage the mainboard’s solder nut.
6.
Close the chassis, as described in Chapter 6.1: Opening and Closing the Chassis, steps 1 to 4.
After installing or removing an mSATA SSD the partitioning of the memory maybe different.
To remove an mSATA expansion card from the shared mSATA/mPCIe socket, perform the following:
1.
Close all applications, shut down the product properly, and disconnect the connection to the power source.
Disconnect all peripherals.
2.
Open the chassis as described in the Chapter 6.1: Opening and Closing the Chassis, steps 1 to 5.
3.
Locate the mSATA card installed into your product.
4.
Remove the mounting screw and spacer, and the mSATA card springs up at an angle of approximately 30° at
the free end.
5.
Gently pull the mSATA card out of the mSATA socket.
6.
Close the Chassis, as described in the Chapter 6.1: Opening and Closing the Chassis, steps 1 to 4.
After installing or removing an mSATA SSD the partitioning of the memory maybe different.
6.5.
Installing and Removing Internal mPCIe Expansion Card
To install an mPCIe card in the shared mSATA/mPCIe socket, perform the following:
1.
Close all applications; shut down the product properly and disconnect the connection to the power source.
Disconnect all peripherals.
2.
Open the chassis as described in the Chapter 6.1 Opening and Closing the Chassis, steps 1 to 5.
3.
Locate the mPCIe card socket and the corresponding solder nut.
4.
Insert the mPCIe card into the socket at an angle of approx. 30° and push the mPCIe card down until the fixing
holes of the card are aligned with the solder nut.
5.
Secure the mPCIe by pressing down on the free end and carefully fasten the mPCIe card to the mainboard
with a mounting screw and spacer (if required) between the mPCIe card and the mainboard.
Do not use too much force when fastening the mPCIe expansion card’s mounting screw. Too
much force may damage the mainboard’s solder nut.
6.
Close the Chassis, as described in the Chapter 6.1: Opening and Closing the Chassis, steps 1 to 4.
