FM Operation
Scanning for Radio Stations
The unit will automatically select a FM radio station with a good signal.
1. Select the TUNER mode by tapping the icon repeatedly on the unit or pressing the
FM/DAB button on the remote control until the display reads “TUNER”.
2. To activate automatic scanning, press and hold the SCAN button on the remote control.
3. All stations found will be automatically stored.
4. To select and listen to a saved radio station , press the / – buttons on the
remote control.
Searching for a Station Automatically
In TUNER mode, press and hold the TU + / – buttons on the remote control until the tuner
starts searching for a station. The tuner will stop searching after tuning into a radio station.
The search may not stop at a station with a very weak signal.
Searching for a Station Manually
In TUNER mode, repeatedly press the TU + / – buttons on the remote control until the
desired frequency reception quality is found.
With FM radio it may be necessary to fine tune each station by pressing the TU + / – buttons on the
remote control repeatedly. Each press will adjust the frequency by 0.05MHz. If reception is still poor
adjust the position of the aerial or try moving the radio to another location.
Searching Mode
1. Press the MENU button on the remote control and then press the buttons to
select SCAN. Press the ENTER button to confirm.
2. Press the
buttons to select STRONG and WEAK. Press the ENTER button to
confirm.
Select weak searching signal is helpful when receiving poor signal reception.
For Better Reception
Fully unwind the FM aerial. Extend the FM aerial and place it in the position that offers
the best sound reception.
21
SDABTIP12_IB_130624_candice.indd 21
24/06/2013 2:43 PM
