20
Gas Connection
Any gas installation must be carried out by a Gas Safe Registered engineer.
Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper.
The connection should be suitable for connecting to 1/2 inch BSP male thread. When the final
connection has been made, it is essential that a thorough leak test is carried out on the hob and
installation. Ensure that the main connection pipe does not exert any strain on the hob.
It is important to install the elbow correctly, with the shoulder on the end of the thread, fitted to the
hob connecting pipe. Failure to ensure the correct assembly will cause leakage of gas.
1. 90 degree connection elbow
2. Washer
3. End of manifold with 1/2 inch BSP male thread
Check the Hob After Installation & Before Using
When the hob has been fully installed it will be necessary to check the minimum flame setting.
To do this, follow the step below,
1. Turn the gas tap to the maximum position and ignite
2. Set the gas tap to the minimum flame position then turn the control from minimum to maximum
several times. If the flame is unstable or is extinguished adjust the gas rate.
3. Perform a gas tightness test.
1
2
3
Summary of Contents for S5GONGW13
Page 1: ...Instruction Manual 5 Burner Gas Hob S5GONGW13 S5GONGB13...
Page 23: ......
