18
Fitting the Hob into the Worktop
When fitted, the metal base of the hob should rest against the worktop.
Do not allow the glass surface of the hob to rest against the worktop
as it could cause damage to the glass.
1. Remove all removeable parts from the hob.
2. Turn the hob upside down and place it on a soft surface to avoid scratching.
3. Measure the width and depth of the outer edge of the hob glass and cut the self adhesive sealing
tape (supplied) to the correct lengths.
4. Stick the sealing tape to the outer edge of the underside of the hob. Ensure the strips of tape fit
together at the corners but do not overlap.
5. Remove the backing strip from the sealing tape and carefully fit
the hob into the aperture.
6. Fit the four brackets to the underside of the hob. Insert the
hooked edge of the bracket into the slot on the underside of
the hob and secure the bracket in place with the screw. Replace
the procedure for the other three brackets.
7. Adjust the position of the brackets depending on the thickness of
the worktop as indicated below and tighten the screws evenly.
Worktop
Hob
If the appliance is to be installed above a cupboard or drawer it is absolutely essential that
you place a separating board between the base of the appliance and the drawer unit.
This must be fixed in place below the hob (at 70 mm measured from the top of the worktop)
to prevent accidental contact with the bottom of the hob which may be hot.
Summary of Contents for S5GONGW13
Page 1: ...Instruction Manual 5 Burner Gas Hob S5GONGW13 S5GONGB13...
Page 23: ......
