13
12
SWITCHING ON AND OPERATION (Fig.1)
Once you have checked that the mains voltage coincides with the voltage indicated on the name plate,
connect the convector.
1.- The Led (f) inform to the user that the convector is connected to the power supply.
2.- Select the power using the power selector command and turn the thermostat command in the direction
of clockwise to its maximum position :
POWER SELECTOR
0
OFF
1.000 W
2.000 W
2.000 W + Support heater *
* Option only for the model
TLS-603T
3.- Once the room has reached the desired temperature, turn the thermostat control anticlockwise until you
hear a slight click. When the thermostat control is in this position, the convector will connect and disconnect
automatically to keep the pre-selected temperature constant.
SUPPORT HEATER (Only TLS-603T)
To accelerate the heating room, it can also connect the support heater (Turbo).
ANTI-FREEZE PROTECTION
The convectors incorporate an anti-freeze device which triggers then convector when the room temperature
drops below +5ºC.
To activate this device just connect the convector to the mains, place the power selector in any of the active
positions and the thermostat control in the position
The convector will remain disconnected until the room temperature drops below +5ºC when it will start
automatically to ensure the temperature is maintained over +5ºC.
This device is particularly useful in places where low temperatures are common and the water pipes are
likely to freeze.
13
PROTECTION AGAINST OVERHEATING
If any operating trouble is produced, the overheating disconnection system will automatically disconnect the
convector. If this occurs:
.- Place the power switch in the “0” position
.- Disconnect the convector from the mains.
.- Let the convector cool down for 15 minutes.
.-. Check that the air inlet and outlet grilles are not blocked. If necessary, clean them with a vacuum cleaner.
.-If the convector still does not work normally after these checks, please contact the extensive network of
S&P Official Services.
MAINTENANCE
The
S&P
convectors do not require any special maintenance. Before cleaning do not forget to disconnect the
convector from the mains.
Wait for the body to cool down and clean with a soft cloth. Use a vacuum cleaner to clean the air inlet and
outlet grilles.
Under no circumstances must the convector be submerged in water or placed under a running tap.
If the convector is not used for a long period of time, we suggest you disconnect it from the mains and keep
the whole apparatus in its own packaging in a dry place.
REMOVAL FROM SERVICE, DISPOSAL AND RECYCLING
EU regulations and our commitment to future generations oblige us to recycle used materials;
please remember to dispose of all unwanted packaging materials at the appropriate recycling points, and to
drop off obsolete equipment at the nearest waste management point.
TECHNICAL ASSISTANCE
The extensive network of
S&P Official Services
guarantees good technical assistance all over Spain. If you
observe any anomalies in the convector, please contact any of the above mentioned Services, where you can
get the correct advice. Any modification that is not strictly necessary for the installation of the device and
carried out by persons outside of the
S&P Official Services
will invalidate the guarantee.
For any queries regarding the S&P Products go to the
S&P After Sales Service
network if is Spanish territory
or your dealer in the world. For the nearest location
you can consult the webpage:
www.solerpalau.com.
