40015 AND 40017 Assembly Instructions
Page 6
Glass Bead #40105
Glass Bead is used in creating a satin or matte finish. Glass Bead is recommended in reclaim
systems or cabinets. (25 Lb. container)
Aluminum Oxide #40098
Aluminum Oxide is a high quality abrasive that is sharper than sand (not recommended) and cuts
twice as fast as sand. It leaves a smooth textured finish with no pits or burrs. Aluminum Oxide is
rougher than glass bead and can be used over and over again. It is one of the most economical
abrasives you can use in any reclaim systems or cabinets. (4/25 Lb. container)
Plastic Grit #40110
Primarily used to strip aluminum and fiberglass. Great for stripping paint, light oxidation and surface
rust. Recommended for use in blast cabinets because it creates very little dust. Works quickly, last a
long time and increases visibility within the cabinet. (10 Lb. container)
Walnut Shells #40112
Walnut shells are recommended for use on “soft” surfaces such as aluminum, glass, wood, and other
areas where no pitting is desired. Leaves a smooth, dull finish. (10 Lb. container)
TROUBLESHOOTING TIPS
PROBLEM
POSSIBLE SOLUTION
Surging of blast flow:
Air pressure too low
Check pressure on air compressor
Too much media
Excessive media consumption:
Media valve open too far
Air pressure too low
Check pressure gauge on compressor
Clogging and plugging of blast flow:
Debris in media
Purge and screen
Media size too large
Use smaller grit size
Nozzle plugs
Use larger nozzle
Nozzle plugs
Adjust media valve 40314
Wet media
Dry media, drain water from air
Moisture in abrasive media:
Wet media
Change or use dry media
Water in air
Drain water from air lines
Water in tank
Empty, dry out and refill
Humid weather:
Moderate humidity
Keep media as dry as possible
Moderate humidity
Use drier or moisture separator
High humidity
Avoid that period of use if possible
