Sandel ST3400, Installation Manual

Page: 46 / 116

6.1.4 Configuration Module Status Page
“CONFIG MODULE STATUS” page may appear during initial turn on and
programming of a unit. This page will only appear again if there is a mismatch
between the configuration information saved in the Configuration Module and the
ST3400. The mismatch identified with the configuration information is shown at
the top of this page, along with the actions that may be taken.
The options displayed on the “CONFIG MODULE STATUS” page are as
follows.
“DISABLE CM” (CM)
When this option is selected no stored data will be read from or written to the
Configuration Module. Selecting “Disable CM” will allow the installer to go
directly to the Maintenance Index page 1.
Note “ CM ” will appear in the upper right corner to indicate that the configuration
module is not operational.
“ST3400 TO CM”:
Selecting this option will allow stored ST3400 configuration data to be written to
the configuration module and stored.
NOTE: When selecting this option ST3400 configuration data will
be written TO the configuration module and overwrite any
existing configuration data in the Configuration Module.
“CM TO ST3400”:
Selecting this option will allow stored Configure Module data to be written to the
ST3400.
NOTE: When selecting this option data FROM the configuration
module will overwrite any existing configuration data in
the ST3400. The configuration module is unaffected.
6.1.5 Tail Number
As part of the configuration, an aircraft identifier (Tail Number) should be entered
on the systems settings page.
6-2
ST3400 INSTALLATION MANUAL 82002-IM-L