Sandel ST3400, Installation Manual

Page: 18 / 116

1.7 Technical Standard Order Stipulation
The following stipulation as presented is required by the federal Aviation
Administration for articles approved under Technical Standard Order. This
statement does not preclude multiple installation and operational approvals in
regard to specific aircraft make, model, or type:
The conditions and tests required for TSO approval of this
article are minimum performance standards. It is the
responsibility of those installing this article either on or within
a specific type or class of aircraft to determine that the aircraft
installation conditions are within the TSO standards. TSO
articles must have separate approval for installation in an
aircraft. The article may be installed only in compliance with
14 CFR Part 43 or the applicable airworthiness requirements.
1.8 Installation and Operational Approval Procedures
The Environmental Qualification Form for the ST3400 is included as an
Appendix within this Installation Manual. It should be referenced to the
categories appropriate to the aircraft type and environment into which the ST3400
is to be installed. The environmental category for the ST3400 should be
stipulated on the STC form.
A “Functional Ground Test Procedures/Report” and an “Operational Flight Check
Procedures Report” are included in an Appendix to this manual. They should be
used as a basis for validating the ST3400 equipment configuration and to verify
proper installation and functional performance. A permanent copy of the STC
form must be filed and maintained by the installing agency. Another copy must
be presented to the aircraft owner for entry into the aircraft maintenance records,
as well as a copy forwarded to Sandel Avionics along with the Warranty
Registration Form, to be filed after completion and installation acceptance.
If any difficulty is experienced with the functionality or operational performance
of the ST3400, contact Sandel for assistance.
ST3400 INSTALLATION MANUAL 82002-IM-L 1-18