INSTALLATION
Regulatory
Information
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: 1) This device may not cause harmful interference and 2) this device must accept any
interference received, including interference that may cause undesired operation.
Any changes or modifications to this device without the express written consent of
S&C Electric Co, may void the user's authority to operate the device.
This device must be professionally installed. It is the responsibility of the installer to ensure
that proper antenna and cable combinations are used in order to remain within FCC Part 15 limits.
The SpeedNet is specifically designed to close the longest possible links. This goal is
accomplished in part by delivering the highest permissible RF output power to the antenna per the
FCC Part 15 Rules. In August 1996, the FCC adopted RF exposure guidelines that established
safety levels for various categories of wireless transceivers. Those limits are consistent with safety
standards previously published by the National Council on Radiation Protection (NCRP) Report
86, §17.4.1, §17.4.1.1, §17.4.2, and §17.4.3 as well as the American National Standards Institute
(ANSI) in §4.1 of "IEEE Standard for Safety Levels with Respect to Human Exposure to Radio
Frequency Electromagnetic Fields, 3kHz to 300GHz," ANSVIEEE C95.1-1992.
The SpeedNet complies with these FCC exposure guidelines when the following precautions
are obeyed:
•
Only install the exact antennas recommended in this User Manual.
•
The cable run for the selected antenna must exceed the minimum length quoted in this
User Manual.
•
All persons must maintain a minimum separation of 12" (30.48cm) from any SpeedNet
antenna.
You should disconnect the AC/DC input power source from the SpeedNet whenever
repositioning the antenna. You are responsible for taking the necessary steps to ensure that these
guidelines are communicated to all persons that may come near the SpeedNet antennas.
Class A Digital Devices
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications.
12
1072-510
