S&C Instruction Sheet 768-550 11
Installation
Connecting the Control Cable
STEP 5.
A shielded control cable is included with the Scada-
Mate Switch for connecting the switch to the
communication and control unit. Remove the
control cable from its shipping carton. The control
cable is provided with multi-pin connector plugs—
male for connec ting to the switch and female for
connecting to the con trol unit. Locate the receptacle
on the back of the switch base and remove the dust
cover. Remove the sensor shorting blocks from the
receptacle and attach the con trol cable plug. Secure
the plug with the con
nector clips. Refer to
Instruction Sheet 768-500. Retain the dust cover
and sensor shorting blocks for future use. See
Figure 7.
STEP 6.
Locate the connector plug on the back of the
communication and control unit enclosure, remove
the dust cover, and attach the control cable plug.
Secure the plug with the connector clips. Retain the
dust cover for future use. See Figure 8.
Control cable
Connector clips
Connector
receptacle
Connector plug
Figure 7. Connect the control cable to the switch. (A Scada-Mate
Switch in the upright mounting configuration is shown.)
Connector plug
Connector clips
Control cable
Connector receptacle
Figure 8. Connect the control cable to the communication and
control unit.
