S&C BankGuard PLUS, Installation Manual

Page: 2 / 24

2
S&C Instruction Sheet 1011-510
Qualified Persons
Ç
WARNING
The equipment covered by this publication must be installed, operated, and maintained
by qualified persons who are knowledgeable in the installation, operation, and main-
tenance of overhead electric power distribution equipment along with the
associated hazards. A qualified person is one who is trained and competent in:
• The skills and techniques necessary to distinguish exposed live parts from non-
live parts of electrical equipment.
• The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualifi ed person will be exposed.
• The proper use of the special precautionary techniques, personal protective
equipment, insulating and shielding materials, and insulated tools for working
on or near exposed energized parts of electrical equipment.
These instructions are intended only for such qualified persons. They are not
intended to be a substitute for adequate training and experience in safety procedures
for this type of equipment.
Read this Instruction
Sheet
Thoroughly and carefully read this instruction sheet before programming, operating,
or maintaining your S&C BankGuard Plus Control. Familiarize yourself with the safety
information on page 3. The latest version of this instruction sheet is available online in
PDF format at www.sandc.com. Select: Support/Product Literature Library.
Retain this Instruction
Sheet
This instruction sheet is a permanent part of your S&C BankGuard Plus. Designate a
location where you can easily retrieve and refer to this publication.
Warranty
SPECIAL WARRANTY PROVISIONS:
The standard warranty contained in seller’s
standard conditions of sale, as set forth in Price Sheet 150, applies to S&C BankGuard
Plus Controls, except that the first paragraph of said warranty is replaced by the following:
(1) General: Seller warrants to immediate purchaser or end user for a period of 10 years
from the date of shipment that the equipment delivered will be of the kind and qual-
ity specified in the contract description and will be free of defects of workmanship
and material. Should any failure to conform to this warranty appear under proper
and normal use within ten years after the date of shipment the seller agrees, upon
prompt notification thereof and confirmation that the equipment has been stored,
installed, operated, and maintained in accordance with recommendations of the seller
and standard industry practice, to correct the nonconformity either by repairing any
damaged or defective parts of the equipment or (at seller’s option) by shipment of
necessary replacement parts. The seller’s warranty does not apply to any equipment
that has been disassembled, repaired, or altered by anyone other than the seller. This
limited warranty is granted only to the immediate purchaser or, if the equipment is
purchased by a third party for installation in third-party equipment, the end user of
the equipment. The seller’s duty to perform under any warranty may be delayed, at
the seller’s sole option, until the seller has been paid in full for all goods purchased
by the immediate purchaser. No such delay shall extend the warranty period.
Introduction