Samyung BNW - 50, User Manual

Page: 39 / 64

39
3) Insert the adapter below the bracket
8.2 Installing movement sensor
Microwave radiation can pass through the glass and nonmetallic walls, you must adjust the microwave’s
range so that it does not exceed the room limits. Otherwise the motion in the next room or moving
traffic along the outer side of the wall will cause the MW detector to trip. Large reflective objects
(especially metals) within the range may distort the patterns of the detective range. If two motion
sensors are installed in the same room or on the opposite sides of a shared wall, the sensors should not
face each other and there must be at least 2 m distance between them.
Picture 2 Motion sensor Exterior
1)
Choose between ceiling or wall adapter
.
Installment place
1. Avoid installing from direct sunlight
2. Install it separately from the vessel’s power
cable
3. Do not install it at the back of the partition
4. Avoid installing near the heat
5. Install it on the stable and hard surface
6. Avoid installing from windy environment
7. Do not install it outside.
Installation instruction
1. Remove the front cover by loosening the screw
at the bottom of the sensor.
2. Loosen the binding screw of PCB and carefully
remove the PCB.
3. Drill the bracket holding screw and wire hole.
4. Refer to the picture beside.
5. Pull the wire through the holes and by using
the binding screw, fix the bracket and sensor
together.
6. Assemble the PCB carefully.
7. Connect the wire with the right terminal and
screw.(refer to 6.4 motion sensor)
8. Set the Dip switch. (refer to picture 3)
9. Assemble the front cover.
10. Fix the sensor adapter on the wall.
Lens
LED
Cover
Binding Screw
2) Place nut
into bracket
5) Assemble the
attached bracket
with detector’ s base
4) Place the
wire into the
bracket
6) Install the sensor
facing to the range
and tighten the
bracket bolt
Bracket Base
Bracket holding
screw