13
B.
General principles in using the SAMURAI fl oor stripper
The SAMURAI fl oor stripper is designed for use either as a standalone unit for small or diffi cult jobs, such as
stairs, or with the handle extension for clearing large areas. The following instructions apply to both usages.
1. Before connecting the unit to a grounded power source, fl ip ON/OFF switch (Fig.15) between both
positions to ensure that switch works. Press and release trigger switch verify that it is in good working
order.
2. Ensure that the fl oor stripper is completely turned off prior to adjusting or relocating the unit.
3. Verify that electrical power is supplied from a grounded and safe source, and that the source is of the
same voltage to that specifi ed on the machine.
4. If using an extension cord, connect it to the machine, then plug the other end into the grounded
receptacle.
5. Position blade on the surface of the material to be removed.
6. Flip on ON/OFF switch to the ON position and tilt the machine forward, maintaining a steady and
consistent angle. If using with handle extension, pull on trigger.
7. Proceed as fast as the machine will allow. DO NOT FORCE MACHINE TO MOVE AT ANY OTHER RATE.
The nylon wheels at the bottom of the machine (Fig.16) are designed to allow the fl oor stripper to
glide on fl oor surface. These wheels MUST REMAIN IN CONTACT with the fl oor at ALL TIMES. The
fl oor stripper is operating at an incorrect angle if wheels are not touching the fl ooring surface. An
incorrectly positioned fl oor stripper may lead to severe damage to the fl oor, operator and the machine
itself.
8. Blade
must
be
fl ush to the surface that it is scraping AT ALL TIMES. Uneven scraping results and
possible damage to job surface can result otherwise. Depending on the width of blade used, the
machine can remove material from 4” to 9” wide. Account for this working width as job proceeds.
9. If unit does not power on, check that the main power switch is switched ON, and that the unit is
connected to a live, grounded receptacle
Operating Procedures cont’d ...
!
DO NOT USE THE SAMURAI AS A PRY BAR, NAIL REMOVER, OR ANY
OTHER PURPOSES EXCEPT THOSE EXPLCITLY STATED IN THIS MANUAL.
ANY UNAUTHORISED OR NON-RECOMMENDED USE CAN LEAD TO SEVERE
BODILY HARM, JOBSITE & MACHINE DAMAGE.
Fig.15:
Location of main power switch
Fig.16:
Location of nylon wheels
