Samsung VCC4320S3A/BOL, User Manual

Page: 11 / 98

EN-9
NOTE :
Replacement filters are available at
your local Samsung distributor.
Press the fixed frame part at the back of the
main body to remove.
CLEANING THE OUTLET FILTER
5
Remove and replace the blocked outlet filter.
OPTION - MICRO FILTER
OPTION
This vacuum cleaner is designed for household use only.
Do not use this vacuum cleaner to clean building waste and debris, toner of laser
printer. Regularly keep the filters in clean conditions to prevent of collecting fine
dust in them. Dry carpet cleaners or fresheners, powders and fine dust such as flour should
be only vacuumed in very small amounts. Always clean the dust bin & filters after vacuuming
them. Do not use this vacuum cleaner with any of the filters or dust bin removed.
Do not use worn, deformed or damaged filters. Always install the filters in the correct position
as shown in this manual. Failure to meet these requirements could cause damage to the
internal parts and void your warranty. Never twist micro filter after washing.
It can be a reason of deformation or damage filter. If filter deformed or damaged please
replace the filter (it can be a reason of penetration of dust and debris into motor).
Please insert filter properly without gap between filter and cover filter (it can be a reason of
penetration of dust and debris into motor).
Thermal protector : This vacuum cleaner has a special thermostat that protects the motor in
case of its overheating. If the vacuum cleaner suddenly shuts off, turn off the switch and
unplug the vacuum cleaner. Make sure that there is power in the socket.
To avoid electric shock, please contact a qualified electrician.
Check the vacuum cleaner for possible source of overheating such as a full dust tank, a
blocked hose, pipe, or clogged filter.
If these conditions are found, fix them and wait at least 30 minutes before attempting to use
the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn
on the switch. If the vacuum cleaner still does not run, contact a service engineer.
WARNING
DJ68-00473H-10.indb 10 2017. 6. 21. �� 5:24
EN-10
PROBLEM CAUSE REMEDY 0
- IF YOU HAVE A PROBLEM
Motor does not start. No power supply.
Thermal cut-out.
Suction force is gradually
decreasing.
Nozzle, suction hose or tube
is blocked.
Cord does not rewind
fully.
Check that the cord is not
twisted or wound unevenly.
Vacuum cleaner does
not pick up dirt.
Crack or hole in hose.
Check cable, plug and socket.
Leave to cool.
Check for blockage and remove
it.
Pull the cord out 2-3m and
push the cord rewind button.
Check hose and replace if
required.
Low or decreasing
suction
Filter is full of dust. Please check filter and, if
necessary, clean as illustrated in
the instructions.
This Vacuum cleaner is approved the following.
EMC Directive : 2004/108/EEC
Low Voltage Directive : 2006/95/EC
Product information
11 / 98