Samsung TB14C52S/XEC, Service Manual

Page: 41 / 106

Alignment and Adjustments (Electrical)
5-8 Samsung Electronics
5-4-8 Center Convergence Adjustment
1. Warm up the receiver for at least 20 minutes.
2. Adjust the two tabs of the 4 pole magnets to
change the angle between them. Superimpose
the red and blue vertical lines in the center
area of the screen.
3. Adjust the Brightness and Contrast controls for
a well defined picture.
4. Adjust the two-tab pairs of the 4 pole magnets,
and change the angle between them.
Superimpose the red and the blue vertical
lines in the center area of the screen.
5. Turn the both tabs at the same time, keeping
the angle constant, and superimpose the red
and blue horizontal line in the center of the
screen.
6. Adjust the two-tab pairs of the 6-pole magnets
to superimpose the red and blue line onto the
green. (Changing the angle affects the vertical
lines, and rotating both magnets affects the
horizontal lines.)
7. Repeat adjustments 2~6, if necessary.
8. Since the 4-pole magnets and 6-pole magnets
interact, the dot movement is complex
(Fig. 5-3).
RED BLUE
BLUE
RED
4-Pole Magnet Movement
GREEN
RED/BLUE
RED/BLUE
GREEN
6-Pole Magnet Movement
Fig 5-3 Center Convergence Adjustment
5-4-9 Dual Tuner AFT Adjustment
Test Equipment
1. TV Generator (PM5518,PM5418,ETC.)
2. DC VOLTMETER
1. Connect DC Voltmeter to AFT terminal of TUNER
IF-MODULE.
After selecting P00, input to IF1 terminal of TU002 (38.9 MHz Using PM5518)
3. After selecting P00, set to 2.5V
+
2.
_ 0.2V (Using FRANCE : T101, PAL/SCAM B/G,I,D/K : L102)