Samsung SU3364, User Manual

Page: 12 / 16

12_ Maintenance
Maintenance
cHEcK ROTATING BRUSH AND DRIVE BELT
You should check your vacuum cleaner’s Rotating
Floor Brush and Drive Belt regularly for wear or
damage. You should also clean the brush and brush
ends of strings, hair, and carpet fibers. These can
wrap around the brush and hamper its ability to
effectively clean your carpet. Also remove any debris
that has accumulated under the brush cover.
1. Unplug the Vacuum Cleaner from electrical outlet.
2. Place handle in Low position and turn vacuum cleaner
over so bottom side is up.
3. Remove the six screws as shown with screwdriver. Lift
the Brush Cover off.
4. Grasp Rotating Floor Brush at both ends and lift.
5. Clean strings, hair and other debris from Rotating Floor
brush, paying particular attention to brush ends.
6. Clean strings, hair and other debris from Motor
Pulley and Drive Belt areas.
7. Check Drive Belt carefully for wear, cuts or
stressed areas.
8. Check Air Passageway for obstructions. Remove
debris from this area.
REpLAcE DRIVE BELT
1. Unplug cleaner from electrical outlet.
2. With Rotating Floor Brush removed from vacuum
cleaner grasp old Drive Belt and remove from
Motor Pulley. Discard old Drive Belt.
3. Place new Drive Belt over Motor Pulley and stretch
other end over Rotating Floor Brush in the space
between the bristles.
4. Place ends of Rotating Floor Brush down into slots
on sides as shown.
5. Turn Rotating Floor Brush by hand several times in
the direction of Motor Pulley. If properly installed,
Drive Belt will center itself on Rotating Brush
crown.
6. Reposition Brush Cover and screws. Insert the
hook on the Brush Cover into the corresponding
groove on the brush and tighten scerws securely.
Be careful of your hands when you replace the drive belt, to avoide physical
injury from sharp plastic film.
WARNING
①
②
③
WARNING
To reduce the risk of injury
from moving parts, turn
off vacuum cleaner and
disconnect Power Plug
from electrorical outlet.
Brush
cover
Motor
pulley
Air
passageway
①
②
Hook