Samsung SRP-350U, Service Manual

Page: 43 / 125

Near end sensor tab
5-1
5 Maintenance and Adjustments
5-1 Adjustment
5-1-1 Remaining Roll Paper Adjustment
Figure 5-1 Adjusting the Paper Near End Sensor
Figure 5-2 Paper Remaining Amount for Paper Spool Diameter
Note : The factory setting is based on a paper roll core with an outside diameter of 18mm. If you use a paper roll
with a cor e with an outside diameter of mor e than 18mm, it is better to change to the upper position
1. Open the paper roll cover.
5-1
5 Maintenance and Adjustments
5-1 Adjustment
5-1-1 Remaining Roll Paper Adjustment
Figure 5-1 Adjusting the Paper Near End Sensor
Figure 5-2 Paper Remaining Amount for Paper Spool Diameter
Note : The factory setting is based on a paper roll core with an outside diameter of 18mm. If you use a paper roll
with a cor e with an outside diameter of mor e than 18mm, it is better to change to the upper position
5-1
5 Maintenance and Adjustments
5-1 Adjustment
5-1-1 Remaining Roll Paper Adjustment
Figure 5-1 Adjusting the Paper Near End Sensor
Figure 5-2 Paper Remaining Amount for Paper Spool Diameter
Note : The factory setting is based on a paper roll core with an outside diameter of 18mm. If you use a paper roll
with a cor e with an outside diameter of mor e than 18mm, it is better to change to the upper position
5-1
5 Maintenance and Adjustments
5-1 Adjustment
5-1-1 Remaining Roll Paper Adjustment
Figure 5-1 Adjusting the Paper Near End Sensor
Figure 5-2 Paper Remaining Amount for Paper Spool Diameter
Note : The factory setting is based on a paper roll core with an outside diameter of 18mm. If you use a paper roll
with a cor e with an outside diameter of mor e than 18mm, it is better to change to the upper position
Note : For your r eference, this shows the diameter at which the near-end sensor is triggered. Note that this figur e
is a calculated value, and there may be some variations depending on the printer.
on the roll when the near-end sensor is triggered, you can change the setting to the upper or Lower position
as described below.
This sensor is set to the step3 position at the factory. If you find that there is not or too enough paper remaining
(Rotate the tab at front side) as described below. (Rotate the tab at front side) as described below. (Rotate the tab at front side) as described below.
2. Rotate the tab at front or rear Position.
Samsung Electro-M
e
chanics