Samsung SRP-350U, Service Manual

Page: 28 / 125

3 Installation and Operation
3- 2
3-1 Installation
3-1-5 Wall Mount Installation
Figure 3-5 Wall Mount #1
1. Press the Push Button. After opening the cover, insert the Wall-Guide L , R
to the Upper-
Left Hole and the Upper-Right Hole inside of the printer (Figure3-5).
from the Main Body (Figure 3-
6
)
3
. Attach the Plate-Spring to the right side of Frame-Body and tighten a screw as illustrated in
the Figure 3-8.
4
. Check whether it works properly by pressing the Push Button after tightening the screw.
(Figure 3-9)
5
. After assembling the Plate Spring, the height will be 7~10[mm] when pressing the Push
Button. If no problem Re-assemble in the reverse order.
6
. After assembling the Case-Lower to Set Body, turn the Set over and attach the BRKT
Hanger to the Case Lower then tighten four screws. (Figure 3-10)
7
. Attach the BRKT Mount to the wall firmly with the eight screws. Be sure that the BRKT
attached properly to match the direction of arrow as illustrated in the Figure 3-11. And the
BRKT Mount should be always fixed vertically. (Figure 3-11)
8
. Insert the BRKT Hanger of Set to the BRKT Mount as illustrated in the Figure 3-12.
Samsung Electro-M
e
chanics
2
. Remove the three screws from the bottom of the Case-Lower. Separate the Case-Lower