Spinpoint M8-DVR OEM Product Manual REV 1.0
41
•
DEV
is reserved.
•
Bit0-bit3 is defined for the binary coded address of the head to be selected in
CHS
mode (e.g. if H3
through HS0 are 0011b, respectively, then head 3 will be selected). HS3 is the most significant bit. In
28 bit
LBA
mode bit0-3 HS3 contains bits 24-27 of the LBA. After command completion, this register
is updated to reflect the currently selected disk address.
•
LBA
is to select the Logical Block Addressing Mode. When LBA=0, disk addressing is by
CHS
mode.
•
When LBA=1, disk addressing is by
LBA
mode. This bit was set to zero when the ATA drive didn’t
support LBA mode.
6.3.4.10 Status Register (Ex. 1F7h)
This register contains the drive status. The contents of this register are updated at the completion of each
command. When BSY is cleared, the other bits in this register become valid within 400 nsec. If BSY=1, no
other bits in this register are valid. If the host reads this register when an interrupt is pending, it is considered
to be the interrupt acknowledge. Any pending interrupt is cleared whenever this register is read.
7
6
5
4
3
2
1
0
BSY
DRDY
#
#
DRQ
Obsolete
Obsolete
ERR
•
B S Y
(Busy)
is set whenever the drive has access to the Command Block registers. The host
should not access the Command Block registers when BSY=1. When BSY=1, a read of any
Command Block register returns the contents of the Status register.
•
D R D Y
(Drive Ready)
indicates that the drive is capable of responding to a command. When
there is an error, this bit does not change until the host reads the Status register. Then the bit
again indicates the current readiness of the drive. This bit clears at power-on and remains clear
until the drive is ready to accept the command.
•
D R Q
(Data Request)
indicates that the drive is ready to transfer a word or byte of data between
the host and the drive.
•
E R R
(Error)
indicates that an error occurred during execution of the previous command. The
bits in the Error register have additional information regarding the cause of the error.
