Export the Configurations to USB Memory
Mode
Export
File Name
07011000
Include N/W Settings
Cancel
Export/Import the Configuration
Apply
Device
None
Cancel
Remote Control Device
OK
Remocon
On
ID:00
ID
Baudrate
Parity
Date
Stop
Duplex
000
9600
None
8
1
Half Duplex
24
_ menu setup
CAUTION
When the Disk end mode is set to
Overwrite
and the HDD overwrites
the data that was previously backed
up, the backup start time may be
changed or the backup process may
be cancelled.
[Disk Overwrite]
When Overwrite is selected, the
previous event data is to be deleted
and the mode is also changed.
[Built-in HDD]
This is a physical hard disk connected to
the IDE cable inside the main body, and it
stores data.
[External HDD]
This is a physical hard disk connected to
the port and jack on the rear of the main
body, and it also stores data. This can be
used as an extended hard disk or backup
hard disk.
Extended HDD: Supplements the built-
in HDD. It is located on the top of the
built-in HDD.
Backup HDD: Used for backup of the
data recorded on the HDD.
[ATA]: Built-in HDD
This is a disk drive implementation that
integrates the controller on the HDD itself.
It is a physical hard disk connected to the
IDE cable inside the main body.
[USB]: External HDD
(Extension HDD or backup HDD)
This is used for external HDD connection.
The external HDD is connected through
this USB port on the front or rear panel.
Export/Import the Configuration
This menu is used to export or import the DVR-
related settings to/from the USB memory.
The related settings are as the following:
Mode:
You can select any of Import and
Export.
File Name:
In case of Export, the file name
is displayed. The file naming convention is
YYMMDD00. “00” is the serial number so it
increases by 1. To change the file name, press
the
ENTER
button. You can change the name
using the virtual keyboard.
File Open:
In case of Import, you can select
the file that you want to import from the USB
memory after pressing the
ENTER
button.
When the importing completes, your DVR
automatically reboots.
Include N/W Settings:
In case of
Export
, this
flag is selected by default. But with
Import
,
you can decide whether or not to copy the
network settings. Be careful when you select
this because it will remove the previous
network settings.
Remote Control Device
This menu enables you to use the Samsung
system keyboard or remote control.
Device
It indicates a remote control device that is
connected to the RS485 port.
ID
This is a unique ID of the device. This ID is
necessary to control multiple DVRs.
Baudrate
Baud rate for communicating with cameras.
It should be the same as the baud rate of
cameras for communication.
Parity
Select one of None, Even, and Odd.
Data
Select one of 7 and 8.
Stop
Select 1 or 2 for stop bit.
Duplex
Select one of Half Duplex and Full Duplex. (Data
exchanging method)
Remocon
Set the remote control to
On
or
Off
. You can
set the ID of remote control to any of 0 to 99.
SHR-5162_Eng.indb 24
2007-06-18 ソタタ・11:48:15