3-18
GB
3-17
DIGITAL VIDEO RECORDER
GB
6
Alarm Record Setup
The following illustrates the intial setting of the
ALARM RECORD SETUP
menu.
①
ALARM ENABLE
You shall select
ON
to start recording in the event of alarming and select
OFF
to prevent
recording in the event of alarming. If you set the
ALARM ENABLE
to
ON
and exit the menu,
the system will begin recording whenever alarm occurs. To force stop the recording during the
alarm recording, press and hold the
STOP
(
■
) button for 3 seconds. Then, the recording by the
current alarm will be stoppted, and the alarm recording will not be performed for the next 5
seconds even if alarm occurs. To completely stop the alarm recording, go into the menu
within that 5 seconds to set the
ALARM ENABLE
to
OFF
. If no action is performed by the
user for 5 seconds, the system returns to the alarm recording mode.
[ON/OFF]
②
ALARM DETECT TYPE
Set to
N. C.
(Normally Close) when the alarm input is Active High, and set to
N.O.
(Normally
Open) when the alarm input is Active Low.
[N.C./N.O.]
➂
ALARM BUZZER
Set to
ON
to have the system activate the Buzzer when a motion is deteced in the input
video or when alarm occurs, or set to
OFF
to keep the Buzzer inactive.
[ON/OFF]
➃
MAIN ALARM TIME
Set the duration for which alarm recording is to be performed when a motion is detected in the
input video or when alarm occurs. The value can be set from 0 seconds to 5 minutes when you
set to
OFF
. If you set to
AUTO
, the alarm recording is performed only during when the alarm
signal is Active.
[5MINUTE/4MINUTE/3MINUTE/2MINUTE/1MINUTE/30SECOND/20SECOND/
10SECOND/AUTO/OFF]
➄
DISK END BUZZER
If set to
ON
, the Buzzer will sound when the HDD is full during the recording; if set to
OFF
, the Buzzer will not sound.
[ON/OFF]
➅
RECORD TIME MARK
If set to
ON
, the recording time will be displayed during playback; if set to
OFF
, it will not
be displayed.
[ON/OFF]
➆
STATUS DISPLAY
Set the location on the screen where the time of recording will be displayed during
playback. Set to
LEFT
to display it on the bottom left of the screen, or set to
RIGHT
to
display it on the bottom right of the screen.
[LEFT/RIGHT]
ALARM RECORD SETUP
ALARM ENABLE
OFF
ALARM DETECT TYPE
N.O.
ALARM BUZZER
ON
MAIN ALARM TIME
10SECOND
PRE ALARM TIME LIMIT
2SECOND
POST ALARM TIME LIMIT
OFF
MAIN ALARM PICTURE RATE
30.00FPS
MOTION DETECTION
OFF
SET AREA & SENSITIVITY
Summary of Contents for SHR-3010
