Samsung SHN-WDS700, User Manual

Page: 14 / 36

1
Smart
Door Lock
SHN-WDS700
1
Double Authentication Mode :
This mode requires both User Card and PIN Code to open
the door, ensuring more security. However, Master PIN Code can open the door regardless of
mode. To enable this mode, more than 1 User Card and PIN Code must be registered. This mode
is disabled by default.
Double-locking :
Double-locking prevents the lock from being unlocked from the outside. You
can enable it by using the [OPEN/CLOSE] button.
Emergency Power Contact :
Continuing to use the lock without replacing batteries when
required will lead to the batteries discharging and cause the lock to malfunction. You can open
the door by touching the external power contacts on the Exterior Unit with a 9V battery and then
touching with the Card or entering the PIN Code.
Indicator Lamp :
Indicates the operational status when the Card is being read or the lock is
in operation.
Intrusion Detection Function :
When the Interior Unit is forcibly detached while the door
is locked, it is detected by the magnetic sensor and an alarm is sounded. (The function is not
activated when the magnet is not used.)The Intrusion Detection function is a basic function and
cannot be enabled or disabled.
Locking Mode (Auto/Manual) :
You can enable or disable the function for locking the door
automatically when it is closed. The factory default is ‘Auto mode’.
- Auto: The door is locked automatically 2 seconds after it is closed. However, it does not function
if the magnet is not used or the batteries are completely discharged.
- Manual: When the door does not lock automatically when it is closed, touch the [Touchscreen]
or the [ OPEN/CLOSE ] button on the Interior Unit will lock the door.
Low Voltage Indicator :
Refers to the state when the operating voltage of the lock is lower
than the standard voltage, and activates the Low Voltage Alarm (“Fur Elise”) to indicate that the
batteries need to be replaced. Use the Emergency Power when the batteries are completely
discharged.
Magnetic Sensor :
Detects the opening and closing of the door.
Malfunction Prevention Function (Mischief Prevention Function) :
When more than
5 failed authentication attempts with unregistered PIN Codes/Cards occur, a warning sounds for
10 seconds, and the lock stops operating for 3 minutes. While lock operation is stopped, a ‘beep’
is sounded every 10 seconds and the lock is activated again automatically after 3 minutes. The
Malfunction Prevention function is a basic function and cannot be enabled or disabled.
Thumbturn Lever :
When the batteries are completely discharged, this device is used to me-
chanically lock or unlock the door from inside.
Master PIN Code :
You can enter only one Master PIN (4-12 digits) Code. You can register the
User PIN Codes/Cards after authenticating with the Master PIN (4-12 digits) Code. You can open
the door with the Master PIN Code, and the factory default is ‘ 1234 ’.
OPEN/CLOSE Button :
A one-touch button to open the locked door. (It is also used to lock the
door from inside in the Manual locking mode.)
Out-of-Home Security Function :
This function prevents intrusions from outside when no
one is home. Pressing the [OPEN/CLOSE] button while the Out-of-Home function is enabled
sounds an alarm. You can enable this function by touch of a certain button.
|
Definitions