connecting to the monitor
Connect the video out port of the camera to the video input port of the monitor.
`
To check the display screen after installing the camera for the first time, you can use the Video
port to check the video screen.
`
You can set the video output type to either NTSC or PAL. (page 29).
`
The Video source (4:3) will be displayed with either side truncated in comparison with the
HD-SDI video.
`
The video source from the HD-SDI port can be displayed on the dedicated monitor. To display the
source on a commercial monitor, you need a converter to convert the video signal as appropriate.
video cable
The cable connecting the camera’s video output and a monitor is a BNC coaxial cable as
shown below.
If the distance between the camera and the monitor exceeds the recommended maximum,
please us an auxiliary video amp.
Maximum video transfer
distance
Recommended cable
specification
100~140m
5C2V(75ohm)
200m
L-6CHD(75ohm)
(SDI-specific Cable)
J
●
in
St
aLL
ation & connection
English
_13
external Day/night Switching input
Day/Night mode of the camera can be switched by signal from an external device.
`
To use this function, <
DAY/NIGHT
> setting of the camera should be set to the <
EXTERN
>.
(Page 27)
motion Detection Signal out
Upon a motion detection, the port outputs signal for an external device for display or operation.
When a motion is detected, the port outputs 3.3V signal.
`
To use this function, <
ALARM OUT
> setting of the camera should be set to <
ON
>. (Page 31)
J
J
