Samsung SCB-9060 Series, User Manual

Page: 15 / 32

15
●
INSTALLATION
un
the
e.
ing/
INPUTTING POWER
Remove the lens cap.
Engage the power. (Use the adapter provided with this product.)
The rated input voltage for this product is AC 24 V, 50/60 Hz.
- This device is not fi tted with a power switch. The device
must be provided with power to turn it
- After checking the label on the cable on the right side of the
camera, connect the output cable of the provided adapter.
1.
2.
3.
Installation
When the resistance value of copper wire is at [20
℃
(68
℃
)]
Copper wire size (AWG)
#24(0.22
2
) #22(0.33
2
) #20(0.52
2
) #18(0.83
2
)
Resistance Ω/m 0.078 0.050 0.030 0.018
Voltage Drop(V/m) 0.028 0.018 0.011 0.006
* Deviations may occur depending on the type of power cable shown in the chart above, and on
the wiring manufacturer.
A 22-18 gauge power wire is recommended for this camera.
Voltage reinforcement will occur based on the length of the power wire. If the adapter
output wire is too long, camera performance may suffer.
Standard voltage for camera operation: AC24V±10%
Operating the heater in a low temperature costs you a lot of power consumption. Insuffi cient
power can cause a product failure. So use only the power outlet with rated AC24V 2.5A.
M




STARTUP
The START screen will appear after the power has been turned on.
After completion of initialization, thermal images will be displayed. (within 30 seconds in room temperature)
1.
2.
The sensor will not operate properly immediately after the power is
turned on, or when switching between NARROW and WIDE ranges.
As a result, thermal images will not display consistently for several
seconds. Menu controls can be used to save values to be applied at
subsequent start-up of the SCB-9060/9080.
NUC(non uniformity correction)
This device will perform a calibration necessary for imaging (NUC) after the internal shutter closes.
During NUC, the screen will freeze momentarily. Please note that this is not a malfunction.