English -
11
installing the hob
WARNING
Be sure the new appliance is installed and grounded
only by qualified personnel.
Please observe this instruction. The warranty will
not cover any damage that may occur as a result of
improper installation.
Technical data is provided at the end of this manual.
SAFETY INSTRUCTIONS FOR THE INSTALLER
•
A device must be provided in the electrical installation
that allows the appliance to be disconnected from the
mains at all poles with a contact opening width of at least
3 mm. Suitable isolation devices include line protecting
cut - outs, fuses (screw type fuses are to be removed from
the holder), earth leakage trips and contactors.
•
With respect to fire protection, this appliance corresponds
to EN 60335 - 2 - 6. This type of appliance may be
installed with a high cupboard or wall on one side.
•
The installation must guarantee shock protection.
•
The kitchen unit in which the appliance is fitted must
satisfy the stability requirements of DIN 68930.
•
For protection against moisture, all cut surfaces are to be
sealed with a suitable sealant.
•
On tiled work surfaces, the joints in the area where the
hob sits must be completely filled with grout.
•
On natural, artificial stone, or ceramic tops, the snap
action springs must be bonded in place with a suitable
artificial resin or mixed adhesive.
•
Ensure that the seal is correctly seated against the work
surface without any gaps. Additional silicon sealant must
not be applied; this would make removal more difficult
when servicing.
•
The hob must be pressed out from below when removed.
•
A board can be installed underneath the hob.
•
The ventilation gap between the worktop and front of the
unit underneath it must not be covered.
02
DISPO
SAL
INS
TR
UC
TIONS
&
INS
TALLING
THE
HOB
NZ64H5747DK_ET_DG68-00660B-02_EN.indd 11
2017-05-25 12:20:38
