38 English
Maint
enanc
e
Maintenance
Burner grates and components
Turn off all surface burners and make sure they have all cooled down.
1
2
3
LL
CC
RR
1.
Remove the center burner griddle(C) following
both sides grates.(L/R)
2.
Remove the burner caps from the burner
heads.
3.
Remove the burner heads from the valve
manifolds to reveal the starter electrodes.
4.
Clean all removable grates, griddle and burner
components in warm, soapy water. Do not use
steel-wool pads or abrasive cleaners.
5.
Rinse and dry grates, griddle and burner
components thoroughly.
8
7
6
6.
Return the burner heads to their positions on
top of the manifold valves. Make sure a starter
electrode is inserted through the hole in each
burner head.
NOTE
See the next page for detailed burner component
re-assembly instructions.
7.
Return the burner caps to their positions on
top of the burner heads. To ensure proper and
safe operation, make sure the burner caps lie
flat on top of the burner heads.
8.
Reinstall the burner grates and griddle in their
respective positions.
9.
Turn on each burner and check if it operates
properly. After verifying that a burner operates
normally, turn it off.
NOTE
•
After cleaning, confirm that the burner port openings aren't plugged.
•
Shake out any excess water and then let burner heads and caps dry thoroughly. Placing the
center burner upside down will allow the water to drain out more easily.
•
Do not wash any burner components in a dish washer.
CAUTION
•
The starter electrodes are not removable. Do not attempt to remove them by force.
•
To avoid chipping, do not bang grates and caps against each other or against hard surfaces,
such as cast iron cookware.
•
The burner head can be blocked by food or dust. Clean the head if it appears blocked. If you
clean the head with water, assemble it only after it is completely dry. If the head is wet, it
might prevent the burners from igniting.
•
To avoid falling down the grates, make sure to remove both sides grates first.
•
Do not attempt to remove center oval burner cap from the head.
Burner reinstall guide
Round burner head
1.
Orient the burner head so that the opening for
the electrode lines up with the electrode.
2.
Install the burner head so that the electrode
passes through the opening for the electrode.
Make sure the burner head lies flat on the
stove top.
