TO AVOID BREAKAGE
CAUTION
CAUTION
Do NOT lift or handle the unit by the cooktop glass.
Fig. 1
C1
C3
C2
C4
1.
The counter top around the cut-out should be flat and leveled (see hatched area on
Fig. 1).
2.
Before installing the unit, measure the heights of the two cabinet sides (C1~C4),
front and back (See Fig. 1) from the floor to the top of the counter.
3.
Level the range using the four leveling legs so that the height from the floor
to the underside of the cooktop glass frame is greater than the tallest cabinet
measurement by at least 1/16".
4.
Remove the Support Frames on the back left and back right of the glass cooktop
(Refer to page 4).
5.
Slide the unit into the cabinet (
DO NOT PUSH THE UNIT HARD
). Make sure the
center of the unit aligns with the center of the cabinet cut-out.
6.
The cooktop glass frame under the cooktop glass
MUST
sit above the cabinet
countertop so the unit is supported by its leveling legs. The cooktop glass should
NOT
directly touch the countertop If the cooktop glass is touching the countertop,
it could break, voiding the warranty.
IMPORTANT
MAKE SURE
the unit is supported by the leveling legs
and
NOT
by the cooktop itself. The cooktop glass must sit above the surface of the
countertops.
English - 7
01
PREP
ARING T
O INS
TALL THE RANGE
