12 English
Using the c
ookt
op burner
s
Using the cooktop burners
Ignition
CAUTION
The knob LED indicates if a burner knob has been turned on.
It does not indicate if the burner flame is on.
Check for an actual flame, whether the knob LED is on or off.
2
1
Make sure all cooktop burners are properly
installed. To light a burner:
1.
Push in the control knob, and then turn it
to the Lite position. The knob LED turns
on and you will hear a “clicking” sound
indicating the electronic ignition system
is working properly.
2.
After the cooktop burner lights, turn
the control knob to shift it out of the
Lite position and turn off the electronic
ignition system.
3.
Turn the control knob to adjust the flame
level.
NOTE
The dual valve located to the center controls the inner/outer flame of the dual
burner [Center].
When the inner / outer flame is on the HI position, the flame size gets smaller from
the outside when turning the knob from HI to LO. To control the inner flame, push
and turn the knob once again at the position where it starts to control inner flame.
Manual ignition
If there is a power failure, you can ignite the burner manually. Use caution when
doing this.
1.
Hold a long gas grill lighter to the cooktop burner you want to light.
2.
Push in the control knob for that burner, and then turn it to the Lite position.
Turn on the grill lighter to ignite the burner.
3.
After the burner is lit, turn the control knob to adjust the flame level.
What’s included
Surface burner
grates (3) *
Surface burners and
caps (5) *
Aluminum griddle (1) *
(NA30K6550T*/
NA36K6550T*)
Cast-iron griddle (1) *
(NA30K7750T*/
NA36K7750T*)
Wok grate (1) *
(NA30K7750T*/
NA36K7750T*)
NOTE
If you need an accessory marked with an asterisk (*), you can buy it from the
Samsung Contact Center (1-800-726-7864).
NA9300K_DG68-00842A-05_EN+MES+CFR.indb 12
2018-08-29 12:46:49
