E-
10
Select the heat mode to raise the room temperature.
1
Press the
(ON/OFF) button to turn on the indoor unit.
- Do not press the
(ON/OFF) button if the remote
controller is on.
Result:
The air conditioner will be turned on with the
most recently used mode.
The air conditioner has a built-in protection
mechanism to prevent the unit from being damaged
when it is started immediately after being:
Plugged in
Stopped
The air conditioner will start up after 3 minutes.
2
To select the HEAT mode, press the
button until
Heat
is
displayed on the remote controller.
Result:
The air conditioner will operate in heating mode.
3
To adjust the temperature, press the
buttons.
The temperature can be set between 16°C(61°F) and
30°C(86°F).
Result:
The temperature will be adjusted by 1°C(1°F)
when the
buttons are pressed.
The air conditioner will start heating if the
set temperature is higher than the room
temperature.
The fan will operate even if the set
temperature is lower than the room
temperature.
4
Select the fan speed by pressing the
button.
Result:
Each time the
button is pressed, fan speed
will change in the following order:
Low
Med
High
Auto
5
To adjust the air swing direction, refer to page 13.
Note
After starting heating operation, the air may not come out
immediately to prevent the cold air from coming out.
(Defrost indicator)
- Defrost indicator will be on while your outdoor unit
defrosts the frost formed during heating operation.
After defrosting is completed, the indicator will be off.
(Air will not come out of the indoor unit while defrosting.)
If you stop running the air conditioner after heating
operation, the air will come out for a while to radiate heat.
If you select cooling mode while the heating mode is in
operation, heating mode will be canceled.
Selecting the Heating Mode
The heating mode can be selected only on the heat pump models.
MWR-WH02_IB_E_33323-1.indd 10
2011-01-10 오후 1:13:38
