Samsung MWR-WG00UN, Installation Manual

Page: 17 / 27

Wired Remote Controller Installation
16 English
Wired Remote Controller Installation
Wir
ed Remot
e C
ontr
oll
er
Installation
Initializing Your Wired Remote Controller Communication
Wired remote controller must be initialized if installation status changes.
࡙
Changing number of ventilator (ERV)/indoor unit or their address
1 Press the and buttons at the same time for more than 5 seconds.
࡙
Your Wired Remote Controller will be initialized, and the device will search for the indoor units/
ventilator(ERV) connected to your Wired Remote Controller again.
Errors displayed on the Wired Remote Controller
Error codes for the Wired Remote Controller and the product connected to your Wired Remote Controller will be
displayed in the LCD display.
Wired Remote Controller error codes
Indication Description Remarks
Communication error between wired remote controller and indoor/ERV units after
successful communication. (communication stop for 3 minutes after detection)
Ęͱʀͱ͔͔Ї̈͝ʀɇϩ̈ͱ͝ɵʪϩиʪʪ͝đɇϑϩʪθ࣍đɇ̈࣎͝ɇ͝ʒƊ̷ɇЭʪ࣍ƊЇɵ࣎Ǯ̈θʪʒŵʪ͔ͱϩʪ
Controllers. (communication stop for 3 minutes after detection)
When tracking between the Wired Remote Controller and indoor units/ventilators
(ERV) is not complete for more than 5 minutes (Including communication error
between indoor units and outdoor units)
Over 16 indoor units and ventilators (ERV) installed.
Reset is required after checking the number of installed indoor units and
ventilators (ERV).
Temperature sensor Open/Short error
Can be detected by
the product with
a temperature
sensor.
kkťŵĮđʪθθͱθ
NOTE
࡙
For the error codes for your indoor/outdoor units and ventilator(ERV), refer to the installation manual of each
device.