ENGLISH-6
Installing the ERV wired remote controller
Installation procedure
1. Push up the bottom part of the ERV wired remote
controller's front cover to disassemble the front cover
from the mounting plate.
ū ERV wired remote controller can be opened in the sliding
way . (Hold the front cover and then lift it up to disassemble
the front cover .)
2. Fix the mounting plate of the ERV wired remote
controller on the wall with 2 screws.
3. Connect the F3, F4 of PCB terminal in ERV to F3, F4 of
ERV wired remote controller terminal.
4. Arrange the connected communication wires
correctly depending on the installation condition.
ū When the ERV wired remote controller is embedded on the
wall: Make the wire go through the hole in the center of the
mounting plate .
ū When the ERV wired remote controller is installed on the
wall: Remove the thin parts on the front and mounting plate
to make the wires go through as seen in the picture .
ū When the wire is extended from the upper side of the ERV
wired remote controller and covered with a protection tube:
Remove the contact point of the protection tube about
1 cm or more so that the front cover can be assembled
without a problem .
5. Reassemble the ERV wired remote controller.
INSTALLATION
ERV Wired remote controller_MWR_VH12N_IM_EN_05309A-00.indd 6
2016-12-23 오후 6:02:53
