3
Observe all governing codes and ordinances.
Required:
n
A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:
n
A time-delay fuse or time-delay circuit breaker.
n
A separate circuit serving only this microwave oven.
Clock
The Clock is a 12- or 24-hour clock. Use Control Setup to change
mode, or to turn on or off Daylight Saving Time.
12 hour mode: Press CLOCK, enter time, press the CLOCK, select
A.M. or P.M., then press Start control again.
24 hour mode: Press CLOCK, enter time, then press the Start
control.
Kitchen Timer
The kitchen timer can be used as a simple timer in the kitchen. Press
the Timer control, enter time, then press the Start control.
Control Lock (Available only on some models)
Activate to avoid unintended start. Depending on your model, the
padlock graphic on the control panel is next to either the Start
control or Cancel control. Press and hold the appropriate control
pad until the signal sounds and the lock indicator appears in the
display. Repeat to unlock control.
Eco Mode (Available only on some models)
Eco Mode
reduces standby power usage.
When you press the
ECO MODE
button once, the display will go
out and the microwave shifts to the mode which minimizes power
usage.
To cancel the
ECO MODE
, press
ECO MODE
button once again,
or press any other button.
Vent Fan
Can control speed and on/off. Comes on automatically at the low
setting when it senses heat from the cooktop below. When this
occurs, the vent fan cannot be turned off. It may stay on for up to 1
hour to cool the microwave oven.
Note : The exhaust fan’s speed will reduce when the oven’s
cooking function is activated.
Cooktop Light
High, low and off. Low setting may be used as night light.
My Settings/Options
Settings for the following may be changed: Weight (lbs or kg),
Sound (on or off), Clock display (12 or 24 hours), Remind end
signal (on or off), Demo Mode (on or off) and Daylight Saving Time
(on or off).
Tones
Programming tones and signals which can be turned off or on
using the Control Setup (My Settings/Options).
Demo Mode
Activate to practice using the control without actually turning on
the magnetron. Use the Control Setup (My Settings/Options) to
activate or deactivate.
Filter reminder (Available only on some models)
The filter is supposed to be cleaned or replaced once every three
or four months. A message of "Filter" or "Clean Filter" appearing on
the display reminds users to clean or replace the filter.
To remove the message "Filter", press the number 0 in standby
mode, or access My Settings / Options > Filter.
To remove the message "Clean Filter", press the
Stop/Clear
button.
Electrical Requirements
Settings
GROUNDING INSTRUCTIONS
n
For all cord connected appliances:
The microwave oven must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current. The
microwave oven is equipped with a cord having a grounding
wire with a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.
WARNING
Improper use of the grounding plug can result in a risk of electric
shock. Consult a qualified electrician or serviceman if the
grounding instructions are not completely understood, or if doubt
exists as to whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install an
outlet near the microwave oven.
Plug into a grounded 3 prong outlet.
Do not use an adapter.
WARNING
STATE OF CALIFORNIA PROPOSITION
65 WARNING (US ONLY)
This product contains chemicals known to the State of
California to cause cancer and birth defects or other
reproductive harm.
Sensor_XAA_DE68-03970G-00_EN.indd 3
2016-06-03 10:52:46
