ENG
2
1
4
3
Setting the Speaker Mode
Signal outputs and frequency responses from the speakers will automatically be adjusted
according to your speaker configuration and whether certain speakers are used or not.
Setting the Test Tone
Press the Test Tone to check the speaker connections and to adjust the speaker levels.
In Stop mode,
press
MENU
button.
Press Cursor
button to move to
‘Audio’ and then
press
ENTER
button.
In the Speaker
Setup, press the
ENTER
button again.
Press Cursor , ,
, buttons to move
to the desired
speaker and then
press
ENTER
button.
•
For C,SL, and SR, each time the button
is pressed, the mode switches
alternately as follows: SMALL
➝
NONE.
•
For L and R, the mode is set to SMALL.
47
48
SETUP
SMALL
: Select this when using the speakers.
NONE
: Select this when no speakers are installed.
2
1
In Stop mode,
press
MENU
button.
Press Cursor
button to move to
‘Audio’ and then
press
ENTER
button.
3
Press Cursor button
to move to ‘TEST
TONE’ and then press
ENTER
button.
•
Although Center CH can toggle between SMALL and NONE,it is not relevant to
speaker settings be signals are distributed to FRONT L-CH and R-CH by
creating a virtual Center CH.(Default setting is SMALL).
•
SPEAKER SETUP ---Available only in DVD.
Note
•
The test tone functin is not available while HDMI AUDIO ON.
Note
•
The test tone will be sent to L
➝
C
➝
R
➝
SR
➝
SL
➝
SW in that order.
If the ENTER button is pressed again
at this time, the test tone will stop.
Press
MENU/EXIT
button to exit the setup screen.
Press
RETURN
button to return to the previous level.
36P~76P(DA79)-NO tape-6-27 2008.7.11 4:19 PM Page 38
