|
14
English
Connections
Installing the Speakers on the Half Tallboy Stand
* HT-F4530H only - Front Speakers
1.
Stretch out the speaker cables as shown and arrange it through the
hole of the stand base .
2.
When done, use the stand driver to tighten the stand nut as shown.
3.
This is the appearance after the speaker is installed. Follow these
steps to install another speaker.
4.
If you want to adjust the height of the speaker, loosen two screws on
the rear of the speaker.
5.
Pull up the speaker in the arrow direction. Fit the speaker in a height
adjusting hole of your choice.
!
CAUTION :
Be careful as an excessive force may result in a physical
damage.
6.
Insert two screws clockwise into the hole on the rear of the speaker
using a screwdriver as shown and tighten back 2 screws.
7.
This is after the height of the speaker is adjusted.
You can repeat these steps above at any time if you want to readjust
the height.
5
3
2
6
1
4
7
HT-F4500_F4530H_F4550_XP_ENG_131223.indd 14
HT-F4500_F4530H_F4550_XP_ENG_131223.indd 14
2013-12-23 2:28:11
2013-12-23 2:28:11
