Samsung Freezer, User Manual

Page: 8 / 44

08_ setting up 08_ setting up
Handles may not have cover depending on
the models.
16. Switch the hinge cap and attach the front leg
cover. Carefully put the freezer door back on.
17.
Tighten the 3 bolts and then connect the wires
back together.
Make sure your freezer is unplugged before
handling electrical wires.
18. Connect the wire on the plastic cover and put the
cover back to its original position.
19. Tighten 2 screws back to its place.
• After reversing the door, make sure rubber
door seal is properly arranged.
• If the product makes noise after reversing
the door, apply some oil on the door seal.
11.
Remove the hinge and the grommet from the
freezer door. Detach the left side hinge cover and
pull the wires out of the hinge cover.
Be careful not to damage the electrical wires
when removing the hinge cover.
12. Use wrench to separate the hinge shaft and then
flip the hinge and reattach the hinge shaft.
13. Reassemble the hinge on the freezer door by
reversing the step 11. Make sure to use right side
hinge cover (which can be found underneath the
removed plastic cover from step 2) and remove
the grommet. After reassembling the hinge, wire
and the hinge cover, switch the side from left to
the right.
14. After switching the hinge, make sure to take out
the right side wire cover, and close it with the wire
cover on the top of freezer door.
15. Take off the handle cover and remove the screws,
make sure to detach the caps and the handle
from the right to left side of the door. (Make sure
to cover the right side with detached caps.)
Hinge cover
Grommet
CAUTION
Grommet
“Cover Wire Door R” can
be found in the packaging
Hinge cap
WARNING
CAUTION
DA99-01951G(EN-1)-0.5.indd 8 2010.12.22 10:10:9 AM