※
Reassembly is in the reverse order of the removal.
Part
Figure
Description
Water valve
1. Remove the two (2) screws from the Base.
2. Lift up the inlet valve and disconnect the inlet
valve wire connector.
3. Release the hose clamp and disconnect hose.
Caution
Caution : When removing the hose clamp, take
care to hold it tightly. The clamp is under tension
and if released, it can become a projectile.
Caution
There will be a residual amount of water in the
valve and valve hose. Use a towel to absorb the
water when removing the valve.
Thermistor
Preparation:
•
2. Release the two(2) screws of Thermistor.
3. Pull out carefully.
: The Thermistor has a seal .
Disassemble the Cover base.
- Refer the “Cover base” disassembly section.
1. Remove the one (1) screws of Cover base and
pull out the Cover base.
it
Disassembly and Reassembly _ 23
