6
3. Using more than two screws, firmly affix the rear cover of the remote controller to the wall, and then connect
communication cables(F3, F4), making sure these cables have reasonable length, to the terminal at the back of the cover.
10 mm (0.4 inch) or more
10 mm (0.4 inch)
or more
50 mm (2 inch) or more
10 mm (0.4 inch) or more
Rear cover
Screw hole
Wire (not supplied)
PCB terminal
Front cover
Wired remote
controller
Hydro unit/Hydro unit HT
Hydro unit/Hydro
unit HT PCB
❋
❋
Before fixing the rear cover, allow
at least 10 mm(0.4 inch) space of
upper side, left side, right side, and
50 mm(2 inch) space of bottom
side.
❋
❋
You must fit the screws into the
screw holes.
❋
❋
Do not tighten the screws on the
PCB terminal with excessive force.
4. Reassemble your wired remote controller.
NOTE
•
Align the controller with the upper groove first, and insert it by turning it downward as shown in the
figure. After assembly, check and confirm that no wires are stuck in the gap between the rear and
front cover.
Wired remote controller installation
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 6
2017-05-25 오후 4:18:28
