C
onnecting &
Setting Up
16
- English
A Set Top Box Cont DVD Re TV : Cable box with a
video/audio output or a satellite receiver
You can record channels by selecting the channel on the cable box. You cannot record one channel while watching
another channel. Be sure that the cable box is turned on.
TO AV 1 IN or
TO AV 2 IN(on the front panel)
Getting Connected
1. Find and Connect the included Cable Box Control cable into
the Cable Box Control jack of the DVD Recorder.
2. Find the Cable Box IR Sensor
To control cable box recording, find the IR sensor.
A. Turn the cable box Off.
B. Hold the cable box’s remote so that it touches
the front of the device (see Figure 1).
C. Move the remote across the front while pressing the
power button On and Off (Figure 2).
(Press and release the power button each time you move the
remote; holding down the button will not work.)
D. When the cable box powers On, you have found the sensor.
E. Remember the location of the sensor.
3. Place the Cable Box Control Wand
Place the Cable Box Control wand underneath the cable box
approximately 1 inch in front of the sensor you found in 2 .
Use the double-sided tape to secure the Cable Box Control wand.
Figure 2
Correct
Figure 1
Incorrect
■
You must select a cable box brand from the table on
pages 103~105.
If you do not know the brand name, please contact your
cable provider.
■
After connecting cable box to the DVD recorder through
the IR Blaster cable, you need to set up the Set Top
Box Control menu. (See pages 38~39)
NOTE
01050A-R145-XAA-ENG-14-30 2006.5.2 11:29 AM Page 16