Troubleshooting _ 23
4. TROUBLESHOOTING
4-1. INFORMATION ITEMS AND DIAGNOSTIC CODES
An occurrence of an Error will make a sound of error melody for 5sec and continuously show one of the Error Displays.
Error Display
Trigger
Action Taken
tC
The Thermistor 1 resistance is very low or high.
• Check for a clogged lint screen.
• Check if the vent system is restricted.
• Check the thermistor resistance.
tC5
The Thermistor 2 resistance is very low or high.
• Check for a clogged lint screen.
• Check if the vent system is restricted.
• Check the thermistor resistance.
dC
The dryer is running with thedoor open.
• Close the door, and run the dryer again.
• Check if the door sensor unit is loose or short.
dF
Incorrect door switch.
• Check if the door sensor unit is loose or short.
bC2
Incorrect button state.
• Check if the display PCB is loose or short.
FC
Invalid power source frequency.
• Check if you are using regular power source frequencies.
• Check the power frequency sensor circuit.
9C1
Electronic control problem (Invalid Voltage).
• Check the PCB and wire harness.
• Check if power is supplied properly.
AC
Electronic control problem (Invalid Communication).
• First check the PCB and wire harness.
• Replace the PCB if the problem persists.
HC
Invalid heating Temp in runningthe dryer.
• Check the PCB and Thermistor.
3C
Motor Relay short problem
• Check the
PBA
.
■
Error Recall
Error Recall mode reminds users of the last error that was detected.
To Enter Error Recall mode Press and hold the model-specific buttons for 8 seconds as specified below.
DVE(G)45T6200*/6000*/6005* :
D Wrinkle Prevent
.
In Error Recall mode, the last error that was detected appears. If no error has been found, nothing is displayed.
