Samsung DV56H9100EV, User Manual

Page: 29 / 132

English - 29
Level Message Status Solution
0
The “Vent Sensor ”
lamp is turned off.
The ductwork is free from
blockages.
-
1
The “Vent Sensor ”
lamp illuminates.
When a part of the duct or
the lint filter is blocked by lint
or a foreign object.
When the resistance is high
because the duct is too long
or bent.
Check the duct
connection and shorten
the duct and straighten it
if necessary.
Check the lint filter or
the duct and clean it if
necessary.
2
The “Vent Sensor ”
lamp blinks.
When the duct is blocked by
lint or a foreign object.
When the resistance is very
high because the duct is too
long or bent excessively.
Check the duct
connection and shorten
the duct and straighten it
if necessary.
Check the lint filter or the
duct and clean it as soon
as possible.
In the LEVEL 2 state, this lamp blinks for 3 hours after the completion of the cycle. (If the wrinkle
prevention function is activated, this message is displayed for up to 3 hours.)
If the power button is pressed or the door is opened, the power is immediately turned off.
For more information about the duct installation, please refer to the “Ducting requirements”
section on page 8.
• Although the dryer is available even if the blockage message is displayed, the drying time
may be extended.
• If the LEVEL 1 message is displayed the first time the dryer is run after the installation,
check the connection and clean the duct. If the LEVEL 1 message appears even
after you have checked and cleaned the ducts, this may indicate that there are some
restrictions of the duct due to the length, condition, etc.
If this occurs, you can use the dryer normally and no countermeasures need to be taken.
However, the drying time may be extended or the drying performance may be degraded.
02 oper
ating instructions, tips
DV9100HA-DC68-03170K-12-EN.indd 29 2018/11/19 14:14:37