Samsung DA68-02535A, User Manual

Page: 21 / 108

setting up _21
Removing residual matter inside the water supply line after installing fi lter
1. Turn ON the main water supply.
2. Press the Water button and push the dispenser pad.
Refer to ‘Checking the control panel’ in the manual (page 22)
3. Flush 3 gallons of water through the fi lter befor use.
(Flush approximately 6 minutes.)
This will clean the water supply system and remove air from the lines.
4. Additional fl ushing may be required in some households.
5. Open the refrigerator door and make sure there are no water leaks coming
from the water fi lter.
A newly installed water fi lter cartridge may cause water to briefl y
spurt from the water dispenser. This is due to air getting into the line.
It should pose no problem to operation.
Check the amount of water supplied to the ice tray.
1. Lift up the icemaker cover and gently pull it out.
2. When you press the Test button for 3 seconds, the ice cube container is fi lled with water from the water
supply tap. Check to make sure the amount of water is correct (see the illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem from within the
main water pipes, not the refrigerator.
• It will take a few minutes to reach the amount of water you want.
• Do not press the test button continuously when the tray is fi lled with ice or water.
Water may overfl ow or ice jamming may occur.
• When the bucket is not installed, the ice maker does not work.
• When ICE OFF blinks on the control panel, reinsert the bucket and/or make sure it’s installed
properly.
CAUTION
01 SETTING UP
Ice maker
1
Test button
Check the water level
2
Water Water Ice Ice
LOCK LO
CK
DA68-02535A(0.0).indb 21 DA68-02535A(0.0).indb 21 2012.10.11 11:48:4 AM 2012.10.11 11:48:4 AM