Samsung C2316, Manual

Page: 238 / 328

TIMERS and TIMER/COUNTERS KS57C2308/P2308/C2316/P2316
11-16
TC0 SERIAL I/O CLOCK GENERATION
Timer/counter 0 can supply a clock signal to the clock selector circuit of the serial I/O interface for data shifter
and clock counter operations. (These internal SIO operations are controlled in turn by the SIO mode register,
SMOD). This clock generation function enables you to adjust data transmission rates across the serial interface.
Use TMOD0 and TREF0 register settings to select the frequency and interval of the TC0 clock signals to be used
as SCK input to the serial interface. The generated clock signal is then sent directly to the serial I/O clock
selector circuit (the TOE0 flag may be disabled).
TC0 EXTERNAL INPUT SIGNAL DIVIDER
By selecting an external clock source and loading a reference value into the TC0 reference register, TREF0, you
can divide the incoming clock signal by the TREF0 value and then output this modified clock frequency to the
TCLO0 pin. The sequence of operations used to divide external clock input can be summarized as follows:
1. Load a signal divider value to the TREF0 register.
2. Clear TMOD0.6 to "0" to enable external clock input at the TCL0 pin.
3. Set TMOD0.5 and TMOD0.4 to desired TCL0 signal edge detection.
4. Set port 2.0 mode flag (PM2) to output ("1").
5. Clear P2.0 output latch to "0".
6. Set TOE0 flag to "1" to enable output of the divided frequency to the TCLO0 pin
+ +
PROGRAMMING TIP — External TCL0 Clock Output to the TCLO0 Pin
Output external TCL0 clock pulse to the TCLO0 pin (divided by four):
EXTERNAL (TCL0)
CLOCK PULSE
TCLO0
OUTPUT
PULSE
BITS EMB
SMB 15
LD EA,#01H
LD TREF0,EA
LD EA,#0CH
LD TMOD0,EA
LD EA,#04H
LD PMG2,EA ; P2.0
←
output mode
BITR P2.0 ; Clear P2.0 output latch
BITS TOE0