Installation of the Drain Tube
Fix the drain tube as shown in the figure.
Installation of the Drain Pan
The procedure for installing the drain pan should be determined by the
condition of the installing area.
In the case of an area where the drain pan can not be directly
installed on the rear side of the unit after installing the air conditioner
.
Example: High storage
In the case of an area where the drain pan can be directly installed
on the rear side of the unit after installing the air conditioner
.
Remove two screws on the lower, right and left sides of the unit.
3
Open the front grill ; refer to page 26.
1
Remove the chassis from the cabinet.
4
Remove the rubber cap inserted into the basepan.
5
Fix the drain pan as shown in the figure, and then connect the drain hose.
(You can use any commercially-available drain hose.)
6
Install the cabinet at the specified area after installing the drain pan,
and then re-assemble it in the original condition.
7
Follow steps 5 and 6 only
1
Remove the front panel.
2-1 Press both sides of the cabinet in the direction of the arrow
as shown in the figure.
2-2 Pull the lower part of the front panel slightly forward.
(below three inches)
2-3 Lift the front panel upward.
2
Applying excessive force to remove the front panel may cause
damage to the tab ; be sure not to use excessive force.
E-
21
E-
30
Installation
Tighten the supplied screw on the lower part of front panel to secure
the front panel.
Rubber cap
Screws(2EA)
2-3
2-1
2-1
2
2-
Gasket
Rear
Drain Tube
Front panel
Bottom-Side View with
Drain Pan and Hose in Place
Rubber cap
Drain Hose
Rear
Drain Pan
Screw
Summary of Contents for AWT17XSHDA
