Samsung AVXCSH023/032/040CE, Service Manual, Page: 91 / 363

Troubleshooting
4-7 Samsung Electronics
7
Press button, then the default value is .
8
Push the button to set the display panel to .
Every time you push the button, the display panel reads
’ ’ ’
’
. . .
’ ’ ’ ’ ’ ’
repeatedly.
10
Push the button to set the display panel to .
Every time you push the button, the display panel reads
’ ’ ’
’
. . .
’ ’ ’ ’ ’ ’
repeatedly.
9
Push the button to set the display panel to .
Every time you push the button, the display panel reads
’ ’ ’
’
. . .
’ ’ ’ ’ ’ ’
repeatedly.
11
Push the button to set the display panel to .
Every time you push the button, the display panel reads
’ ’ ’
’
. . .
’ ’ ’ ’ ’ ’
repeatedly.
12
Push the button to set the display panel to .
Every time you push the button, the display panel reads
’ ’ ’
’
. . .
’ ’ ’ ’ ’ ’
repeatedly.
11
9 8
7 10
12
✳
Setting is not required if you must
a value which has a default.
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key, to set the display part to and check the display part.
The display part shows .
Press the Mode Selection key, to set the display part to and check the display part.
The display part shows .
Step 4 : Pressing the ON/OFF button ( )
When pressing the operation ON/OFF key with the direction of remote control for unit, the sound "Ding" or "Diriring" is heard
and the OPERATION ICON( ) lamp of the display is flickering at the same time, then the input of option is completed. (If the
diriring sound isn't heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote control.
Second, Re-insert the battery into the remote control.
Third, Press ON/OFF key with the direction of remote control for set.
• Error Mode
1st If all lamps of indoor unit are flickering, plug out, plug in power plug again and press the ON/OFF key to retry.
2nd If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code
is set up for its model.