Samsung AC026MNLDKH, Installation Manual

Page: 30 / 36

30
Installation Procedure
Ins
tallation Pr
oc
edur
e
English
Step 18 Setting indoor unit addresses
and installation options
Set the indoor unit address and installation option with
remote controller option. Set the each option separately
since you cannot set the ADDRESS setting and indoor
unit installation setting option at the same time. You
need to set twice when setting indoor unit address and
installation option.
Setting an indoor unit address
1 Press the and buttons at the same time for more
than 3 seconds and then a Main menu will be displayed.
2 Press the / button to select and then press
button to enter a Sub-menu setting screen.
3 Press the / button to select and then press
button to enter a Indoor Address setting screen.
1 2 3 4 5 6
Data bit
NOTE
• The Main/RMC Address which is currently setting will
flicker.
• Data bit 1 and 2 present Indoor unit main address
checking
• Data bit 3 and 4 present Indoor unit main address
setting(outdoor unit reset is needed to set).
• Data bit 5 and 6 present Indoor unit RMC address
setting/checking.
4 Press the / button to set the Indoor unit Main/
RMC Address.
5
Press the button to save and complete the option
setting.
6 Press the button to exit to normal mode.
NOTE
• Press the button anytime during setup to exit
without setting.
• Address will not be applied if you don't press
button.
• Setting Main/RMC Address of an Indoor unit is
available only with a master wired remote controller.
Setting an indoor unit installation option
In order to check and set the indoor unit installation
option code use the wired remote controller and follow
the directions below.
1 Press the and buttons at the same time for more
than 3 seconds and then a Main menu will be displayed.
2 Press the / button to select and then press
button to enter a Sub-menu setting screen.
3 Press the / button to select and then press
button to enter a Indoor unit installation option code
setting screen.
NOTE
• The first digit represents the page number and the
remaining five digits are installation option.
• The total option codes are 24 digits. You can set
six digits at a time and it is distinguished by page
number (0, 1, 2, 3).
4 Press the / button to set the installation option
code in order. Press button to go to the next page.
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 2
RESERVED
Exterior
temperature
sensor
Central
control
RESERVED
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1
Drain
pump
Use of Hot
Coil
Use of
Heater
Controller
variables
for
auxiliary
heater
RESERVED
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2
External
control
External
control
output
S-Plasma
ion
Buzzer
Number
of hours
using
filter
SEG19 SEG20 SEG21 SEG22 SEG23 -
3
Individual
control of
a remote
controller
Heating
setting
compensation
RESERVED
Away
Set OFF
Timer
-