Samson TROVIS 3730-1, Translation Of Original Instructions

Page: 139 / 144

EB 8484-1 EN 16-5
Annex A (configuration instructions)
Code Reading/values Description
P22 Start initialization
Start initialization by pressing . Press to cancel the initial-
ization process. As a result, the valve moves to the fail-safe posi-
tion when it has not been initialized properly beforehand. If it has
been initialized properly, the positioner returns to closed-loop op-
eration using the former parameters.
After a power supply failure during initialization, the positioner
starts with the values of the last initialization (if available).
P23 Start zero calibration
Start zero calibration by pressing . The zero calibration pro-
cess can be interrupted by pressing . The control valve returns
to closed-loop operation.
After a power supply failure during zero calibration, the positioner
starts with the settings from the last zero calibration.
Note: A zero calibration cannot be started when E1 error code ex-
ists.
P24 Manual mode
Turn to enter the set point.
P25 Reset Parameters are reset to their default setting.
The positioner can only return to closed-loop operation after it has
been re-initialized.
P26 Restart The positioner is briefly switched off and on again. Calibration
values remain saved. The positioner continues closed-loop opera-
tion after a restart.
P27 Firmware version
Installed firmware version is displayed. Press to display the last
four digits of the serial number.