Samson Media 6 Z, Mounting And Operating Manual

Page: 30 / 48

30 EB 9527-3 EN
Memory pen communication
−
Operation: the display switches back
again to
ESM mode 30 seconds after the
device was last operated.
−
A power supply lower than 6.6 V causes
LOW BAT and the measured reading to
appear on the display.
−
After the power supply has fallen to 6 V,
only
LOW BAT appears on the display
without the reading. The batteries need
replacing.
On-site operation
Deactivate write protection by setting switch
4 to OFF .

Press and hold key for approx. 8 s until
UCW appears at the top of the display.
Press

or

key to switch to BAT MODE

Press key to confirm reading. BAT MODE
blinks.
Press

or

key to select battery opera-
tion.
–
ON = 1/OFF = 0 –

Press key to confirm setting.
Activate write protection by setting switch 4
to ON .
9 Memory pen communication
In hazardous areas, only the intrinsically
safe SAMSON memory pen must be con-
nected to the serial interface for data ex-
change.
9.1 Data transmission using a
memory pen
The memory pen is used to store and transfer
data. It allows standardized data records
(tank type and associated gas data) to be
transferred to Media 6 devices on site with-
out requiring a computer by simply plugging
the pen into the serial RS-232 interface
.
A key tag can be attached to the memory
pen for identification.
The user-specific data are transferred to the
memory pen either using the TROVIS-VIEW
software and a computer or copied from a
configured Media 6 device.
Depending on the status set in
TROVIS-VIEW, the memory pen can be used
to read and write, read only or write only
(see Table 7).
Memory pens with data records or existing
configurations for previous Media 6 versions
up to firmware version 2.11 are fully com
-
patible with Media 6 devices with firmware
version V3.00 and higher.
Such records or configurations do not need
to be loaded to TROVIS‑VIEW for conversion
any longer.
NOTICE
!
Note