Samson EB 3773 Series, Mounting And Operating Instructions

Page: 37 / 68

EB 3773 EN 11-1
Removal
11 Removal
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
Risk of fatal injury due to the ignition of an
explosive atmosphere.
Î
For mounting and electrical installation in
hazardous areas, observe the explosion
protection approvals as well as the
relevant electrotechnical regulations and
the accident prevention regulations that
apply in the country of use. EN 60079-
14 applies in Europe: Electrical
installations design, selection and
erection
Î
Installation, operation or maintenance of
the limit switch must only be performed
by personnel who has undergone special
training or instructions or who is autho-
rized to work on explosion-protected de-
vices in hazardous areas.
Risk of fatal injury as a result of electro-
static discharge at the housing.
Î
Ensure that the device, cables and other
plant components cannot rub against
each other.
1. Put the limit switch out of operation (see
the 'Decommissioning' section).
2. Remove the wires for the power supply
from the limit switch.
3. To remove the limit switch, loosen the two
fastening screws on the device.
DANGER !
DANGER !